how do i exit the installers code for my ge networx

On LED touchpads, the five function lights start flashing.Įnter the program code (factory default is 9 7 1 3). To delete transmitters, do the following: 1.Įnter * 8 at the keypad. The transmitter can be reactivated by turning segment 1 on zone back on, or a new one can be learned into the zone. This procedure makes the receiver ignore a transmitter, but does not remove the transmitter identification from the receiver’s memory. The following section describes how to delete transmitters from the receiver. LCD touchpads will display instructions when accomplishing tasks. If you press #, it does not save changes to the current segment, but it does save changes made in previous segments.

The panel waits for the next location entry. If you enter a number higher than 30 (the default value is 40), you disable the feature. Check the control panel installation manual to determine if this setting is available. This applies only to specific countries outside the US. The short supervision time prevents arming if a transmitter has not checked in within the set time. If you choose 0, the fire supervision window is set to 256 hours.Įnter the new short supervision time (up to 30 minutes). If you choose 0, the normal supervision window is set to 256 hours.Įnter the new fire supervision time (0 to 255 hours) and press *. On LED touchpads, the Armed LED turns on to indicate the control panel is waiting for a programming location entry.Įnter 195 # to enter location 195, segment 1.Įnter the new normal supervision time (0 to 255 hours) and press *. On LED touchpads, the five func- tion lights start flashing.Įnter the program code (factory default is 9 7 1 3).Įnter the DIP switch setting module number and press #. To change the transmitter supervision windows, do the following: 1.Įnter * 8 at the keypad.

How do i exit the installers code for my ge networx